|
|
|
|
Mike Dunn, Team Mopar Top Fuel Dragster (4.561/319.60), qualified number one position. "After struggling for almost half the season, it looks like our Team Mopar Dragster is back on track. We haven't been number one qualifier since Columbus last June. Like our crew chief Ken Veney always says, it's either the clutch or the fuel system which makes these Top Fuel Dragsters run. "The first qualifying run on Saturday, we decided to experiment with the car to see how much the track would hold. The car just spun the tires as soon as it left the line. That's what nice about being number one qualifier, it allows you the luxury to try different things during a national event. "On the final qualifying run, we wanted to back-up what we ran yesterday but because of the changing weather conditions, Ken Veney just de-tuned the motor a touch. The weather had changed dramatically from the first session to the second. A lot of teams were not qualified going into that final session like Joe Amato and Kenny Bernstein. They both made good runs and got into the field. As soon as I hit the throttle, the car lifted the front end and carried the wheels very gently then settled back down after a quick tug of the brake. About the 1000-foot mark, some cylinders started to mix it up a bit. Even though it was only a qualifying run, it was still cool for the fans to see side-by-side 4.59 elapse-times. "I'm still hoping we can improve for tomorrow's elimination's as it will be tough. Anyone of these guys can take you down and put you on the trailer early in the day. We'll just go up there and run our own game. It will be near impossible to regain the lead this late in the season but if we can regain some points and move up a couple spots, it will show everyone that we fought until the very end." Dean Skuza, Matco Tools/Team Mopar Dodge Avenger Funny Car (5.148/279.27), qualified number ten position. "Well if we could figure out what our Matco Tools/Team Mopar Dodge Avenger likes for clutch set-up, we could have some consistent performance. We tested in Dallas prior to coming to Houston in hopes of trying to get a handle on the clutch management system. It felt good to have held the number one spot during Friday's qualifying session as everything seemed to be okay on the car. "On the Friday night session, the car went back to its ugly ways and just killed the tires right off the starting line. We thought we had the clutch sorted out but apparently not as we found some other problems within the car. The timing is so critical on when the clutch engages that it will make or break you in a run. On the third session it still struck the tires around the 60-foot mark and I had to click it off early. With the threat of rain, we didn't change much and had the same results on the final qualifying run.
"With what we are learning about the car, we still need to speed up the
curve of knowing how much clutch the car likes. We only made one good
pass out of four during the qualifying sessions this weekend in Houston
and that is not good if we plan on going rounds and winning races.
|
|